My buttons and triggers turned much less and fewer responsive over time. Then a set off change tweaked and allowed half vary in all positions. Fed up, I appeared up a disassembly information and started rigorously separating the shell. From what I keep in mind the fasteners are both T5 or T6 w/safety pins. First I cleaned the set off switches on the again half, then the buttons and set off meeting, then the entire entrance half. After reassembly all capabilities are 100% responsive though the triggers have somewhat stick when first pressed. I feel that’s simply from residue from the alc swabs. I by no means was capable of repair my situation with the paddles, the nub that contacts the precise button isn’t giant sufficient so the paddle hits the again of the controller earlier than urgent the button. I’ve a plan to drop a little bit of solder on the nubs to offer the paddles a bit extra elevation away from the case. submitted by /u/South-Coat4178 |