I discovered a easy answer to repair you out of guarantee controllers with sticky set off buttons. The cushion/bumpers hold the triggers from being excessively loud and create a pleasant really feel, so if your home is filled with Xbox gamers you know the way loud buttons can drive you somewhat loopy 🤪 To take away the previous pad: You must pop off the again part of the controller case with a plastic pry device to entry the realm that serves as a cushion/bumper to your set off buttons. Take away the previous cushion/bumper with 91% rubbing alcohol and a q-tip. It’s going to disintegrate from the alcohol. Take away the rest of the clear adhesive portion underneath the previous black cushion/bumper with a toothpick (it clear and arduous to see, however it’s best to have the ability to scrape it off in a single piece). Substitute pad: I used the very small finish part of a 3M Command strip. The very finish of those strips solely have adhesive on one facet and a pleasant sturdy cushion materials on the opposite, so you utilize an exacto knife and minimize that small part off after which minimize it to dimension (you'll want to chop it shorter and add a forty five diploma angle on one finish). Peel the adhesive cowl off many of the manner and use tweezers to position it the place the previous bumper was positioned. When it's in place press the set off down to carry it then maintain it down with the set off button for 30 seconds. Check the motion of the triggers and if it’s acceptable put the case again collectively and get again to gaming! This will likely take some trial and error to get good, however you'll determine it out! There’s additionally somewhat plus; you possibly can nonetheless use the 3M Command strip! submitted by /u/BurlyBurlz |